Level Washer - Whirlpool W10200890B Installation Instructions Manual

14.
Secure drain hose
Laundry Tub Standpipe
4.5"
4.5"
(113 mm)
(113 mm)
A
A
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with beaded tie strap (A). This will
help reduce the chance of drain water splashing on the floor.

LeveL Washer

IMPORTANT:
Leveling your washer properly reduces excess
noise and vibration.
15.
Prepare to install leveling feet
Prop up front of washer about 4" (102 mm) with a wood block or
similar object that will support weight of washer. Then screw jam
nut onto each foot to within 1" (25 mm) of foot base.
16.
Install front leveling feet
Screw feet into threaded holes at front
corners of washer until jam nuts touch washer, but are not tight.
Tilt washer back, remove wood block. Gently lower washer to
floor and slide washer to its final location. Remove cardboard
used to protect floor.
Wall
4.5"
(113 mm)
A
1"
(25 mm)
17.
Engage rear leveling feet
Tilt washer forward; self-adjusting rear feet will click into place.
Gently lower washer to floor.
18.
Check levelness of washer
Place level here
Place a level on top edges of washer, checking each side
and front. Rock washer back and forth to make sure all four
feet make solid contact with floor. If not level, tip washer and
adjust feet up or down, repeating as necessary.
Not Level LEVEL Not Level
7