Table of Contents
Advertisement
Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily
soiled loads which
need more detergent.
(Extra detergent
can require
an extra rinse.)
1. Push Control
Knob in.
2. Turn clockwise
to any
l
on the dial.
See above
drawing.
3. Pull Control Knob out. The washer
will fill to selected
level; agitate
2
minutes; drain and spin.
For a drain and spin
Your washer can be set to drain and
spin out water.
1. Push Control
Knob in.
2. Turn clockwise
to the bar just before
the OFF area in any cycle.
See
above
drawing.
3. Pull Control Knob out. The washer
will drain and spin.
For agitation
and spin speeds
in each cycle, see pages
6-9.
Cleaning the lint filter
Clean
filter after every load for
best filtering
results. NOTE: The load
type will vary the amount
of lint
build-up.
To clean:
1. Lift off the agitator
barrel.
2. Wash or wipe the filter clean
in the
bottom of the agitator
barrel. The
filter is not removable.
3. Replace
the agitator
barrel and
snap into place.
10
Advertisement
Table of Contents
