SAFETY INSTRUCTIONS. OPERATING INSTRUCTIONS.. Starting Your Washer What Happens in Each Cycle OTHER OPERATING INSTRUCTIONS. For a Rinse and Spin 01987 Whirlpool Parts and features LOAD LAUNDRY SIZE INFDRMATION TEMPERATURE Copyjour Model and Serial Numbers here When you need service...
Additional Safety Instructions ALWAYS store detergent, laundry aids other materials in a cool, place where children can’t reach them - in a locked cabinet if possible. ALWAYS read and follow instructions on packages of detergent and laun- dry aids - especially warnings precautions.
Operating instructions Starting Your Washer Be sure to measure and add detergent, a sorted load in the washer . Select a LOAD SIZE Turn the knob to point to a setting that describes the size of load you want to wash. Set the knob on or between EX SMALL [a few small items) and LARGE (a full load).
Page 5
Select CYCLE and WASH TIME; . Start the washer Push in the Control Knob and turn it to the right. It must be pushed and turned only clockwise. Start the washer by pulling the Control Knob. The washer will fill to the level you set with wash water of the selected temper- ature.
What Happens in Each Cycle* Each cycle has different agitation kinds of fabrics, Numbers on the dial in each cycle agitation time. When the Cycle Control Knob is set to a number before agitation and timing starts. After agitation until it points to OFF and the cycle ends.
Page 7
NOTE: You may hear the sound of water spraying cycles. In some cycles, colb water is sprayed the rinsing. Gentle Wash System For better fabric care in the REGULAR and PERMANENT PRESS cyc speed is reduced during the last few minutes of wash time. NOTE: Always use cold rinse water for permanent...
Page 8
KNITS/GENTLE Cycle A cycle that gently washes and spins lightly to moderately soiled delicate fabrics washable knits. Use for washing heavily soiled loads that require maximum soil removal. Double the amount detergent recommended when using the SUPER WASH Cycle. A SOAK WASH Minutes Minutes...
Page 9
The washer will proceed to the REGULAR/HEAVY Cycle. If you want a different cycle to follow SUPER WASH, push in the cycle control knob, turn to the cycle time you want, pull knob out to start.
Other operating instructions For a rinse and spin You may need an extra rinse and spin for heavily soiled loads which need more detergent. (Extra detergent can require an extra rinse.] 1. Push Control Knob in. 2. Turn clockwise to any on the dial.
Liquid bleach dispenser Always measure bleach. Do not guess. Never use more than 1 cup (250 ml) for a full load. Use less with lower water level settings. Follow directions on bottle for safe use. Use a cup with a pouring spout to avoid spilling.
Caring for your washer WHEN NOT WASHING, keep both water faucets turned off, this takes the pressure off the water inlet valve and hoses. REMOVE SHARP OBJECTS such as pins, buckles, etc., from clothes before washing. Close metal zippers. AFTER WASHING, use a soft dry cloth to wipe the outside and inside dry.
Winterizing Because some water stays in the washer, freezing can cause a lot of damage. If your washer stored or moved during the cold weather... 1. Shut off both water 2. Put a quart of R.V faucets. Disconnect or automobile and drain water antifreeze inlet hoses.
If you need service or assistance, we suggest you follow these five steps: Before calling for assistance... Performance problems often result from little things you can find and fix yourself without tools of any kind. If your washer does not fill: Is the power supply cord...
Page 15
Whirlpool appliance. ‘If you must call or write, please pro- vide: model number, serial number, date of purchase, and a complete description of the problem.
Damage to washer caused by accident, of God or use of products not approved Any labor costs durlng the limited warranties. WHIRLPOOL CORPORATION SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSE- QUENTIAL DAMAGES. Some states do not allow the exclusion or limitation of incidental...