Siemens xTronic HG241 5UC Instructions Manual page 6

5. Adjust Broil Burner Orifice
Broil Orifice Conversion
Tightened, but not fully seated
Natural Gas Setting
CAUTION!
DO NOT overtighten the broil burner orifice.
Overtightening may result in damage to the pin inside
the orifice. This affects cooking performance. It could
cause inconsistent flames and unintentional release of
carbon monoxide.
Remove oven door (see section "Removing Oven Door"
in Use and Care manual).
Remove Broil Burner Assembly. The broil burner
assembly is attached to the top of the oven cavity with 7
screws. Remove screws and gently pull broil burner
assembly straight out being careful not to detach
electrical wires. Place broil burner against back wall of
oven cavity.
Adjust Broil Orifice. The orifice is located behind the
broil burner in the back oven wall (See Figure 5). Use a 1/
2" deep socket driver with 3" minimum extension to turn
orifice clockwise until it stops (2- 2 1/2 turns). DO NOT
OVERTIGHTEN.
Replace Broil Assembly. Replace broil assembly being
careful to feed all wires through back wall of oven.
Reinsert all 7 screws.
Note: The air shutter on the broil burner fits over the
orifice when installed correctly.
Conversion Instructions - Oven (Gas Ranges Only)
LP Gas Setting
6. Adjust Bake Burner Orifice
Bake Orifice Conversion
Fully seated
Natural Gas Setting
Tighten Bake Orifice. The bake burner orifice is located
below the air shutter (See Figure 6). Reach it through the
access hole in the interior back panel of the warming
drawer cavity. Use a 1/2" wrench to turn orifice clockwise
until it stops (2 1/2 - 3 turns). Unlike the broil burner
orifice, the bake burner orifice should be tightened as
far as it will go in order to ensure that complete
conversion has occurred.
Figure 5 - Broil Orifice: Oven Cavity Side View
Bake Orifice
Figure 6 - Bake Orifice and Air Shutter
LP Gas Setting
Broil Orifice
Shutter