Table of Contents
Advertisement
Available languages
Available languages
Tools and Parts
Gather the required tools and parts before starting installation.
The parts supplied are in the washer basket. Do not put the
expanded foam plug back into the washer.
Tools needed for connecting the drain hose and
water inlet hoses
Pliers that open to 1
Flashlight (optional)
Parts supplied:
A
A. U-shaped hose form
B. Water inlet hoses (2)
C. Flat water inlet hose washers (4)
Tools needed for securing the drain hose and
leveling the washer
Adjustable or open end wrench
Level
Wood block
Ruler or measuring tape
Parts supplied:
A
B
A. Beaded tie strap
B. Front leveling feet with nuts (2)
C. Rear self-adjusting feet (2)
4
INSTALLATION REQUIREMENTS
" (3.95 cm)
B
C
" (14 mm)
C
Alternate Parts You May Need
Your installation may require additional parts. If you are interested
in purchasing one of the items listed here, call the toll-free
number on the cover or in the "Assistance or Service" section.
If You Have
You Will Need to Buy
Laundry tub or
Sump pump system (if not already
standpipe taller
available)
than 96" (2.4 m)
1" (2.5 cm)
2" (5 cm) diameter to 1" (2.5 cm)
diameter
diameter standpipe adapter,
standpipe
Part Number 3363920
Overhead sewer
Standard 20 gal. (76 L) 39" (99 cm) tall
drain tub or utility sink and sump pump
(available from local plumbing suppliers)
Floor drain
Siphon break, Part Number 285834;
additional drain hose,
Part Number 8318155 and connector
kit, Part Number 285835
Drain hose too
Drain hose, Part Number 8329541 and
short
connector kit, Part Number 285835
Lint clogged drain
Drain protector, Part Number 367031
and connector kit, Part Number 285835
Water faucets
2 longer water fill hoses:
beyond reach of
6 ft (1.8 m) Part Number 76314,
fill hoses
10 ft (3.0 m) Part Number 350008
Location Requirements
Selecting the proper location for your washer improves
performance and minimizes noise and possible washer "walk."
Your washer can be installed in a basement, laundry room,
closet, or recessed area. See "Drain System."
IMPORTANT: Do not install or store the washer where it will be
exposed to the weather.
Proper installation is your responsibility.
You will need:
A water heater set to deliver 120°F (49°C) water to the
washer.
A grounded electrical outlet located within 4 ft (1.2 m) of
where the power cord is attached to the back of the washer.
See "Electrical Requirements."
Hot and cold water faucets located within 4 ft (1.2 m) of the
hot and cold water fill valves, and water pressure of
20-100 psi (138-690 kPa).
A level floor with a maximum slope of 1" (2.5 cm) under entire
washer. Installing the washer on carpeting is not
recommended.
A sturdy floor to support the washer weight (washer, water
and load) of 315 lbs (143 kg).
Do not store or operate your washer in temperatures at or below
32°F (0°C). Some water can remain in the washer and can cause
damage in low temperatures. See "Washer Care" for winterizing
information.
Advertisement
Table of Contents
