Bosch CRS180 Operating/Safety Instructions Manual page 4

2610003213 08-08 CRS180
Safety Rules for Cordless Reciprocating Saws
Hold power tools by insulated gripping
surfaces when performing an operation
where the cutting tool may contact hidden
wiring. Contact with a "live" wire will make
exposed metal parts of the tool "live" and
shock the operator.
Use clamps or other practical way to
secure and support the workpiece to a
stable platform. Holding the work by hand
or against your body is unstable and may
lead to loss of control.
Do not drill, fasten or break into existing
walls or other blind areas where electrical
wiring may exist.
unavoidable, disconnect all fuses or circuit
breakers feeding this worksite.
Keep hands away from cutting area. Do
not reach under the material being cut.
The proximity of the blade to your hand is
hidden from your sight.
Keep hands from between the gear
housing and saw blade clamp (plunger).
The reciprocating blade clamp (blade
plunger) can pinch your fingers.
Do not use dull or damaged blades. Bent
blades can break easily or cause kickback.
Before starting to cut, turn tool "ON" and
allow the blade to come to full speed. Tool
can chatter or vibrate if blade speed is too
slow at beginning of cut and possibly
kickback.
Always wear safety goggles or eye
protection when using this tool. Use a
dust mask or respirator for applications,
which generate dust.
Secure material before cutting. Never
hold it in your hand or across legs. Small
Before using battery charger, read all
instructions and cautionary markings on
(1) battery charger, (2) battery pack, and (3)
product using battery.
Use only the charger which accompanied
your product or direct replacement as
listed in the catalog or this manual. Do not
substitute any other charger. Use only Bosch
approved chargers with your product. See
Functional Description and Specifications.
8/21/08 8:39 AM
If this situation is
Battery/Charger
-4-
Page 4
or thin material may flex or vibrate with the
blade, causing loss of control.
Make certain all adjusting screws (knobs)
and the blade clamp are tight before
making a cut. Loose adjusting screws and
clamps can cause the tool or blade to slip and
loss of control may result.
When removing the blade from the tool
avoid contact with skin and use proper
protective gloves when grasping the blade
or accessory. Accessories may be hot after
prolonged use.
When using the saw hook always be
aware that the the blade is exposed.
Always hang the tool in an area where
yourself and bystandards can not accidently
make contact with the blade.
Some dust created by
!
WARNING
power sanding, sawing,
grinding, drilling, and other construction
activities contains chemicals known to
cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement
and other masonry products, and
• Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment, such
as those dust masks that are specially
designed to filter out microscopic particles.
Do not disassemble charger or operate the
charger if it has received a sharp blow,
been dropped or otherwise damaged in
any way. Replace damaged cord or plugs
immediately. Incorrect reassembly or
damage may result in electric shock or fire.
Do not recharge battery in damp or wet
environment. Do not expose charger to
rain or snow. If battery case is cracked or
otherwise damaged, do not insert into
charger. Battery short or fire may result.