Stihl HT-KM Instruction Manual page 8

English
Always start the cut with the engine at
full throttle.
Always cut with a correctly sharpened,
properly tensioned chain – the depth
gauge setting must not be too large.
Perform cross-cut from the top
downward to avoid the chain pinching in
the cut.
If branch is thick or heavy, make a
relieving cut – see chapter on "Using the
Pole Pruner".
To reduce the risk of injury, take special
care when cutting branches under
tension. Always make a relieving cut on
the compression side first and then
perform the bucking cut at the tension
side.
To reduce the risk of injury, take special
care when cutting shattered wood
because of the risk of injury from slivers
being caught and thrown in your
direction.
If on a slope, stand on the uphill side or
to one side of the branch to be cut.
Watch out for rolling branches.
Note when reaching the end of a cut that
the unit is no longer supported by the
guide bar in the cut. You have to take the
full weight of the machine since it might
otherwise go out of control.
Always pull the unit out of the cut with
the chain running.
To reduce the risk of accidents, use your
pole pruner for limbing and pruning only.
It is not designed for felling.
Make sure your saw chain does not
touch any foreign materials: Stones,
nails, etc. may be flung off and damage
the saw chain.
6
If the rotating chain makes contact with
a rock or other solid object there is a risk
of sparking which may cause easily
combustible material to catch fire under
certain circumstances. Dry plants and
scrub are also easily combustible,
especially in hot and dry weather
conditions. If there is a risk of fire, do not
use your pole pruner near combustible
materials, dry plants or scrub. Always
contact your local forest authority for
information on a possible fire risk.
Maintenance and Repairs
Service the machine regularly. Do not
attempt any maintenance or repair work
not described in the KombiTool and
KombiEngine instruction manuals. Have
all other work performed by a servicing
dealer.
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer. STIHL dealers are
regularly given the opportunity to attend
training courses and are supplied with
the necessary technical information.
Only use high-quality replacement parts
in order to avoid the risk of accidents
and damage to the machine. If you have
any questions in this respect, consult a
servicing dealer.
STIHL recommends the use of genuine
STIHL replacement parts. They are
specifically designed to match your
model and meet your performance
requirements.
To reduce the risk of injury,always shut
off the enginebefore carrying out any
maintenance or repairs or cleaning the
machine. – Exception: Carburetor and
idle speed adjustments.
Stopping the engine
before checking chain tension.
–
before retensioning the chain.
–
before replacing the chain.
–
before rectifying problems.
–
Observe sharpening instructions – keep
the chain and guide bar in good
condition at all times for safe and correct
handling of the saw. The chain must be
properly sharpened, tensioned and well
lubricated.
Always change the chain, guide bar and
sprocket in good time.
Store chain lubricant in properly
labelled, safety-type canisters only.
HT-KM