Test Input - Honeywell FF-SPS4 Series Installation Manual

Test input

If the test function is used (and if optimum alignment is achieved) the indicators react as
follows:
Table 1-4 Automatic restart mode and start interlock mode
indicators status
(1) when a test is initiated, the emitter stops emitting infrared light.
Table 1-5 Start and restart interlock mode
indicators status
(1) when a test is initiated, the emitter stops emitting infrared light.
107063-11 EN FR26 GLO 800 Printed in France
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Receiver Emitter indicators
status
Light on
Receiver Emitter
indicators
status
Light on
Optical Relays
signal status
Sufficient Energized
Absent (1) De-energized
Sufficient De-energized
Sufficient Energized
Light off
Optical Relays
signal status
Sufficient Energized
Absent
De-energized
(1)
Sufficient De-energized
Sufficient De-energized
Sufficient De-energized
Sufficient Energized
Light off
Actions
Close to the external
test contact (1)
Release the external
test contact
If a failure is detected
If no failure is detected
Flickering light
Actions
Close to the external test contact (1)
Release the external test contact
Press the start push-button
If a failure is detected
If a failure is detected on the FSD
monitoring loop
If a failure is detected
Flickering light
11