Panasonic CF-74 Series Supplementary Instructions Manual page 10

Installing the Software
10
Log on to Windows as an Administrator.
11
At [Welcome to the Found New Hardware
Wizard], select [No, not this time], and
then click [Next].
12
Click [Install from a list or specific loca-
tion (Advanced)], then click [Next].
CAUTION
If "CP2102 USB to UART Bridge Controller" is not dis-
played, press [Cancel] and start from step 11 again.
13
Click [Search for the best driver in these
locations], add the check mark for [In-
clude this location in the search:], input
[C:\SiLabs\MCU\CP210x\WIN]
then click [Next].
* The destination folder where you installed the driver in
2
step 4 . If you selected another destination folder in step 4 ,
input the address of the folder you selected.
14
Click [Finish].
The same screen as step 11 appears again.
15
Repeat steps 11 - 14 to install another
driver.
After these steps, be sure to install CheckNet.
( page 11)
10
*2
, and