Graco C Series Instructions-Parts List Manual page 13

CLAMP CLUTCH HOUSING
NOTE:
A standard steering wheel puller and
two
1/4-28 NOTE: Refer to Fig 25-2,
x 3 or 4 in. long screws are required to remove the
clamp.
NOTE: Refer to Fig 25-1
1.
Remove the four capscrews
(8)
and lockwashers
(9)
which hold the clutch housing (2) to the engine.
1.
2 .
3.
Loosenthe two
(16) ontheclamp (3)~woking 2. Remove the capscrew ' ( 1 5 ) , lockwasher
(80)
and
throughthe slot at the bottom
of
the clutch housing ( 2 ) .
washer
(99)
from beneath the mounting plate (D).
Install two screws
(B)
of the tool (A) In two of the
threaded holes in the clamp ( 3 ) . Tighten the screw (C) Remove the engine key ( 1 3 ) .
until the clamp comes off.
4.
Pull
Off
the Clutch housing ( 2 ) .
Skip ahead to Reassembly, page 2 6. Step 3, or con-
tinue to the right. 5. Skip ahead to Reassembly, page
26, Step
1,
Fig 25-1
"
0155