Tachometer; Fuel Injection: Ulysses Models; Dynamic Digital Fuel Injection Iii (Ddfi Iii); Check Engine Lamp - Buell XB Series Owner's Manual's

2. See Dash Panel: Ulysses
display.
3. Simultaneously press (M) and (R) buttons for 2-seconds or until clock display
flashes.
4. Press (M) button to set hours and (R) button to set minutes.
5. After time has been set, simultaneously press (M) and (R) buttons to exit setting
mode and start clock operation.

Tachometer

See OPERATING RECOMMENDATIONS section. Do not operate the engine above
maximum safe RPM as shown under OPERATION (red zone on tachometer). Lower
the RPM by upshifting to a higher gear or reducing the amount of throttle. Failure to
lower RPM may cause equipment damage. (00159a)
See Dash Panel: Ulysses
revolutions per minute (RPM).

Fuel Injection: Ulysses Models

Dynamic Digital Fuel Injection III (DDFI III)

Your motorcycle features Buell's Dynamic Digital Fuel Injection (DDFI III). This
system allows for precise fuel and engine management under different operating
conditions.
Fuel injected vehicles have no fuel valve or enrichener system. These functions are
controlled by an electronic control module.

Check Engine Lamp

See Dash Panel: Ulysses
indicator panel to the right of the tachometer. Its purpose is to indicate whether or not
the engine management system is operating normally.
https://www.motorcycle-manual.com/
Models. Press mode (M) button (8) to toggle to clock
Models. The tachometer (10) registers the engine speed in
Models. The red check engine lamp (4) is located in the
Top of page