Brother QL-600 User Manual page 12

Set Up the Label Printer
c
Thread the DK Roll through the Label Printer.
• Align the edge of the DK Roll with the upright edge of the Label Output Slot.
• Check that the DK Roll is threaded straight so that the labels are not skewed.
• Push the first label through the Label Output Slot until the end comes out of the slot as shown.
d
Close the DK Roll Compartment Cover.
IMPORTANT
• Do not leave any printed labels in the Label Printer. Doing so will cause the labels to jam.
• When not in use, remove any DK Rolls from inside the Label Printer and close the DK Roll Compartment
Cover to prevent dust and debris from accumulating in the Label Printer.
1
6