Install The Handle; Install The Can Rack; Refrigerator Shelves; Normal Sounds - Whirlpool GARF06XXMG00 Use And Care Manual

4. Place the mat in the top tray.
NOTE: Tuck the mat behind the mat pegs to keep the vent holes
clear as shown.
1
2
1. Mat pegs
2. Vent holes

Install the Handle

1. Untape and open the door.
2. Install the handle using (4) #8 x
as shown.
1
1. Handle screws

Install the Can Rack

NOTE: Maximum load is (35) 12 oz. cans.
1. Slide the 4 can rack posts between the notches on the door liner.
2. Check to make sure the rack is firmly in place.
1
1
1. Can rack posts

Refrigerator Shelves

To install shelves:
1. Determine the shelf placement inside the refrigerator.
2. Place the shelf into the desired shelf glide and slide it toward the
back fully past the shelf stop.
To remove shelves:
1. Lift the shelf up and over the shelf stop in the back.
2. Pull it toward you until it comes out of the shelf glide.
in. countersink handle screws
1
1

Normal Sounds

Your new refrigerator may make sounds that your old one didn't
make. Because the sounds are new to you, you might be concerned
about them. Most of the new sounds are normal. Hard surfaces, such
as the floor, walls, and cabinets, can make the sounds seem louder.
The following describes the kinds of sounds and what may be
making them.
Your refrigerator is designed to run more efficiently to keep your
food items at the desired temperatures and to minimize energy
usage. The high efficiency compressor and fans may cause your
refrigerator to run longer than your old one. You may also hear a
pulsating or high-pitched sound from the compressor or fans
adjusting to optimize performance.
Rattling noises may come from the flow of refrigerant or items
stored inside the refrigerator.
As each cycle ends, you may hear a gurgling sound due to the
refrigerant flowing in your refrigerator.
You may hear water running into the drain pan during the defrost
cycle.
You may hear clicking sounds when the refrigerator starts or
stops running.

REFRIGERATOR USE

Using the Control

For your convenience, your refrigerator control is preset at the
factory. When you first install your refrigerator, make sure that the
control is still preset to the mid-setting 5 as shown.
To turn your refrigerator off, turn the refrigerator control to the off
position as shown.
NOTE: Your product will not cool when the refrigerator control is in
the off position.
1. Off position
Adjusting Controls
The mid-setting indicated in the previous section should be correct
for normal usage. The control is set correctly when beverages are as
cold as you like.
If you need to adjust the temperature, wait at least 24 hours between
adjustments and then recheck the temperature.
To make the refrigerator colder, adjust the control to the next higher
setting. To make the refrigerator less cold, adjust the control to the
next lower setting.
7