Install Properly; Level Refrigerator-Freezer; Remove Sales Labels; Clean It - Whirlpool ETl8SK Use And Care Manual

No-frost refrigerator-freezer
Table of Contents

Advertisement

Install properly...
1.
Allow 3 inches (7.5 cm) between overhead cx
inets and the refrigerator top.
Remove sales labels...
Remove the Consumer Buy Guide label, tape
and any
inside
labels
before
using the re-
frigerator.
To remove
any remaining
glue:
1.
Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area
with liquid
hand
dishwashing
detergent before removing glue as described
in step II.
DO NOT USE rubbing
alcohol
or flammable
or
toxic
solvents,
such as acetone,
gasoline,
cac-
bon tetmchloride,
etc. These can damage
the
material.
NOTE: DO NOT REMOVE ANY PERMANENT
IN-
STRUCTIONS
LABELS INSIDE YOUR REFRIGER-
ATOR.
Do not remove
the Tech sheet fastened
under
the refrigemtor
at the front.
2. Allow at least an inch (2.5 cm] between the re-
frigerator condenser on the back and the wall.
3. Allow YZ inch (1.25 cm] on each side of the re-
frigerator for ease of installation.
4. If the refrigerator
is to be against a wall, you
might want to leave extra space on the hinge
side so the door can be opened wider.
-
idL;r*tRh*e,w j: n*
Level refrigerator-freezer.. .
RAISE
LOWER
This refrigerator
has 2 threaded
levelling
legs
that are shipped in a separate package.
1.
Screw these legs all the way into bolt holes in the
bottom front corners of the refrigerator.
2. Slide the refrigerator into place.
3. Adjust the front legs to level the refrigerator.
- To raise corners, turn legs in direction shown.
- To lower corners, turn legs in direction shown.
4. Check with level.
Clean your refriger-
ator before using it.
See cleaning
instruc-
tions on page 8.
Clean it...
3-PRONG
GROUNDING
TYPE WALL RECEPTACLES
REFRIGERATOR
POWER CORD
3-PI
GI ROUNDING
PLUG
RECOMMENDED
GROUNDING
METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly
grounded
electrical
supply
is
required. It is recommended
that a separate cir-
cuit serving only this appliance
be provided.
Do not use an extension
cord. Use a recepta-
cle which
cannot
be turned
off with a switch
or
pull chain.
See
individual
electrical
requirements
and grounding
instruction sheet in your literature
package.
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Et18sk

Table of Contents