Bevel Cut - Bosch 3924B-24 Operating/Safety Instructions Manual

Saw Operations

Bevel Cut

• A bevel cut is made at 0° miter and any bevel angle in the
range of -2° to 47°.
• There are two (2) factory set bevel stops at 0° and 47°.
(See Adjustment section if adjustments are required.)
• The cast in bevel scale faces the operator for easy
reading.
• There is a positive crown molding stop at 33.9°.
Disengage this stop unless using. (See cutting Crown
Molding for details.)
• The bevel lock handle is spring loaded and can be
repositioned by pulling handle out, rotating to desired
position and engaging by releasing for use in tight
spaces.
• Use sliding base/fence as appropriate. (See Sliding
Base/Fence Extension page 54.)
Follow these instructions for making your bevel
cut:
1. Move the sliding fence to proper position 1. (See Sliding
Fence on page 54.)
2. Loosen the bevel lock handle. Tilt the head assembly to
desired bevel angle 2. Tighten the bevel lock handle
(Figure 28).
3. Properly position workpiece 3. Make sure work piece is
clamped 4 firmly against the table and the fence 5.
Use clamping position that does not
WARNING
!
interfere with operation. Before switching
on, lower head assembly to make sure clamp clears guard
and head assembly.
4. Activate the switch. Lower the head assembly and make
your cut.
5. Wait until blade comes to a complete stop before
returning head assembly to the raised position and/or
removing workpiece.
FIG. 28
4
1
58
5
2
3
0°