Table of Contents
Advertisement
By briefly pressing the power button, the display returns to its active state. Once the program is
finished, the device will automatically return to Active Mode and the backlight of the display will be
active again for 1 minute. To terminate the program, press the "X" symbol in the top right corner.
STAND-BY MODE
If the device is in Active Mode and no button or scrolling function has been pressed for 1 minutes, the
device will go into Stand-by Mode to conserve battery power. In this mode nothing can be seen on the
display. Press on/off button to exit Stand-by Mode and return to Active Mode.
Aside from conserving battery power, the Stand-by Mode is also used to enable automatic running of
programs at a pre-set time and day. The BioHarmonex
so the Stand-by Mode is essential for the automatic programming function to operate.
AUTO MODE
In order for the automatic running of programs to function, the device must have the Auto Mode set to
'ON'. If the Auto Mode is set to 'Off', programs can still be run but the running of any program set to run
automatically at a pre-set time in the future will be suspended. For more information about Auto mode,
see "Programming" section.
OFF MODE
To turn the device off, press and hold ON-OFF button for 3-4 seconds until the power-off message
appears while the device is in Active, Stand-by or Program Mode.
ATTENTION:
In this mode the alarm function and running of any program automatically at a pre-set time is not
possible.
BIOHARMONEX 4.0 USER'S GUIDE
is not designed to turn itself on automatically,
16
Hide quick links:
Advertisement
Table of Contents
