Changing The Light Bulb; Removing The Base Grille; Ice Cube Trays; Optional Automatic Ice Maker - Whirlpool EDI9SK Use & Care Manual

Changing the light bulb...
To change light bulb behind refrigerator
consoles:
1. Pull control knob straight off.
2. Pull bottom of control panel straight out.
3. Lift top of panel off supports.
4. Replace with a 40-watt appliance bulb
5. Replace panel in reverse order.
Removing the base grille...
To remove the grille:
\
\
1. Open the doors.
2. Pull grille outwards as shown
PULL OFF THE DIAL;
PULL OUT AT THE BOTTOM
To replace the grille:
1. Line up grille support tabs with metal clips
3. Do not remove Tech sheet fastened behlna
2. Push firmly to snap into place
grille.
3. Close the doors.
Ice cube trays...
If cubes are not used, they may shnnk The mov-
rng cold air starts a slow evaporation The longer
cubes are stored, the smaller they get
To r emove ice:
1. Hold tray at both ends.
2. Slightly twist.
Optional automatic ice maker...
If you have the automatic Ice maker accessory,
or If You plan to add one later (Part No. ECKMF-62).
there are a few things You will want to know
l
The ON/OFF lever is a wire signal arm
Downfor making ice automatically
Up...to shut off the ice maker.
DO NOT TURN ICE MAKER ON UNTIL IT IS CON-
NECTED TO THE WATER SUPPLY.
LOWER
z
SIGNAL
l
The dial or lever on the side of the Ice maker
changes the size of the cubes.
9 Shake the bin occasionally to keep cubes sepa-
rated, and to obtain increased storage capacity
l
It is normal for ir@ rroccenk tn
ho nitnrhad
hy n
corner. They will break apart easily.
9 You will hear water running when ice maker is
working. You'll hear ice fall into the bin. Don't let
these sounds bother you.
l
The Ice maker will not operate until the freezer
is cold enough to make ice. This can take
overnight.
l
Because of new plumbing connections, the first
ice may be discolored or off-flavored. Discard
the first few batches of ice.
continued on next page