Toro Groundsmaster 7210 Series Operator's Manual page 35

Figure 49
Preparing to Perform a Parked or Recovery
Regeneration
1. Ensure that the machine has fuel in the tank for
the type of regeneration you are performing:
•
Parked Regeneration: Ensure that you
have 1/4 tank of fuel before performing the
parked regeneration.
•
Recovery Regeneration: Ensure that you
have 1/2 tank of fuel before performing the
recovery regeneration.
2. Move the machine outside to an area away from
combustible materials.
3. Park the machine on a level surface.
4. Ensure that the traction control or motion-control
levers are in the N
5. If applicable, shut off the PTO, and lower the
cutting units or accessories.
6. Engage the parking brake.
7. Set the throttle to the low I
Performing a Parked or Recovery
Regeneration
CAUTION
The exhaust temperature is hot (approximately
600°C (1,112°F) during DPF regeneration. Hot
exhaust gas can harm you or other people.
• Never operate the engine in an enclosed
area.
• Make sure that there are no flammable
materials around the exhaust system.
• Never touch a hot exhaust system
component.
• Never stand near or around the exhaust
pipe of the machine.
Important:
The computer of the machine cancels
DPF regeneration if you increase the engine speed
from low idle or release the parking brake.
position.
EUTRAL
position.
DLE
1. Access the DPF Regeneration menu, press
the center button to scroll down to either the
P R
ARKED
R S
EGEN TART
right button to select the start the regeneration
(Figure 50).
g224628
2. At the V
ERIFY FUEL LEVEL
have 1/4 tank of fuel if you are performing the
parked regeneration or 1/2 tank of fuel if you are
performing the recovery regeneration, and press
the right button to continue
35
S option or the R
EGEN TART
option (Figure 50), and press the
Figure 50
screen, verify that you
(Figure
ECOVERY
g224402
g224629
51).