Before Using Your Refrigerator; Refrigerator; Cleaning Your Refrigerator; Plugging It In - Whirlpool 2183013 Use And Care Manual

Before Using Your
Refrigerator
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it, and level it.
Cleaning your refrigerator
Removing packaging materials
Remove tape and any inside labels (except
the model and serial number label) before
using the refrigerator.
To remove any remaining glue:
l
Rub briskly with your thumb to make a ball,
then remove.
OR
l
Soak area with liquid hand-dishwashing
detergent before removing glue as
described above. Do not use sharp
instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners. These can
damage the material. See "Important
Safety Instructions" on page 3.
NOTE:
Do not remove any permanent
instruction labels inside your refrigerator. Do
not remove the Tech Sheet fastened under
the refrigerator at the front.
Cleaning it before use
After removing all packaging materials,
clean your refrigerator before
using it, if necessary. See
cleaning instructions on pages
16 and 17.
Plugging it in
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere
fused and properly grounded electrical
supply is required. It is recommended that a
separate circuit serving only this appliance
be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do
not use an extension cord.
See Electrical Requirements and Ground-
ing Instructions Sheet in your Literature
Package.
3-prong grounding
type wall receptacle
grounding plug
WITH QUESTIONS OR COMMENTS