Siemens SIPROTEC Manual page 4

Preview
Validity
Additional Support
Training courses
Target audience
4
This manual is valid for the SIPROTEC device:
• 6MD662/3/4 (firmware version V4.20 or higher),
• 6MD662/3/4 (firmware version V4.70 or higher)
• at use of the PROFIBUS DP redundancy function (ref. to chap. 1)
with
• PROFIBUS DP communication module, firmware version 03.00.03 or higher,
• PROFIBUS DP communication module, firmware version 04.50.02 or higher
• at use of the PROFIBUS DP redundancy function (ref. to chap. 1).
For device parameterization have to be used:
• DIGSI 4.21 considering the preconditions explained in the manual
"SIPROTEC Communication module, PROFIBUS DP - Communication profile"
(ref. to page 3),
• DIGSI 4.30 or higher,
• DIGSI 4.40 or higher at use of
• Transformer tap change commands (ref. to chap. 4.1.2) and
• Transformer tap position indications (ref. to chap. 4.2.4),
• DIGSI 4.71 or higher at use of
• the PROFIBUS DP redundancy function (ref. to chap. 1),
• PROFIBUS DP standard mappings 3-1 to 3-n
(n = device type dependent number of standard mappings).
For questions regarding SIPROTEC4 devices, please contact your Siemens repre-
sentative.
Individual course offerings may be found in our Training Catalog and questions can be
directed to our Training Centre. Please contact your Siemens representative.
Protection engineers, commissioning engineers, personnel concerned with adjust-
ment, checking and service of selective protective equipment, automatic and control
facilities and personnel of electrical facilities and power plants.
SIPROTEC PROFIBUS DP - Bus mapping 6MD662/3/4
C53000-L1840-B011-03