Battery Recharge - Midland G9 Plus Instruction Manual

Battery recharge

Connect the socket of the wall adaptor to a mains power socket and in-
sert the jack of the wall adaptor into the desktop charger plug. It takes
12/14 hours to fully recharge.
Place your transceiver into the cradle of the desktop charger. The red led
of the charger will light up.
When charging is complete take the transceiver out of the cradle and
detach the socket of the wall adaptor from the mains.
Do not overcharge the batteries! When these are fully charged the char-
ging process does not stop automatiCALLy. Do not forget therefore, to re-
move the transceiver from the charger as soon as the batteries are char-
ged, otherwise the radio and batteries may be damaged.
Do not try to charge alkaline batteries or non rechargeable batteries.
Make sure that when you charge the radio, only rechargeable NI-MH
batteries or the supplied battery pack should be contained in the battery
compartment! Alkaline batteries are not rechargeable! Batteries which
are not suitable to be recharged may leak, explode or even burn and cau-
se damage!
Using a different battery charger other than the one specified can cause
damage to your device or may even cause explosions and personal in-
juries.
Do not throw batteries into fire or place them near heat as this may cause
explosions or personal injuries. Dispose of the batteries according to the
procedures set out by local regulations.
Do not mix old and new batteries or batteries of different types or batteri-
es which have been used in different manners.
22 | Midland G9/G9E Plus instruction guide