Using The Cd-Rom Manual; Reading The Cd-Rom Manual - Sony UP-D75MD Manual

Using the CD-ROM
Manual
The supplied CD-ROM includes manuals for this printer
(in English and French). The copies of these manuals are
created in pdf (Portable Document Format).
Preparations
One of the following programs must be installed on your
computer in order to use the operation manuals
contained on the CD-ROM disc.
• Adobe Reader Version 6.0 or higher
Memo
If Adobe Reader is not installed, you can download it
from the following URL:
http://www.adobe.com/
Adobe and Adobe Reader are trademarks of Adobe Systems
Incorporated in the United States and/or other countries.

Reading the CD-ROM Manual

To read the manual on the CD-ROM, proceed as follows.
1
Insert the CD-ROM disc in your CD -ROM drive.
The manuals are saved in the Instructions For Use
folder.
2
Select and click the manual that you want to read.
Memo
The files may not be displayed properly, depending on
the version of Adobe Reader. In such a case, install the
latest version you can download from the URL
mentioned in "Preparations" above.
Note
If you lose the CD-ROM disc or you cannot read it for
some reason, you can purchase a new CD-ROM disc.
Contact your nearest Sony service representative.
4
Using the CD-ROM Manual / Attaching a Ferrite Core to a USB Cable
Attaching a Ferrite Core
to a USB Cable
Before connecting a USB cable (not supplied) to the
printer, you should attach a supplied ferrite core to its
cable for noise prevention. To conform to radiation
standards, attach the supplied ferrite core to the USB
cable of your device as described below.
1
Release two stoppers on the ferrite core to open it.
2
Slip the USB cable through the ferrite core and
position it at the base of the USB connector to the
printer.
3
Close the ferrite core until you hear a click.
Note
When the ferrite core cannot be secure because the USB
cable is thin, secure it using a tape.
Securing a USB cable
After you connect a USB cable to the printer, it is
recommended that you secure the USB cable to prevent
it from being accidentally disonnected using the cable
stopper.