Operation - Graco 236661 Instructions Manual

Operation

Operation
To reduce the risk of serious bodily injury, which can
result if the tank pressure is not fully relieved, always
follow the Pressure Relief Procedure, page 6,
before opening the tank cover or fill port.
Over-pressurizing the tank or accessories could
cause a part to rupture. To reduce the risk of serious
injury, including fluid injection and splashing in the
eyes or on the skin, or property damage, never
exceed the maximum air and fluid working pressure
of the lowest rated component in your system.
1. Fill the pressure tank as explained in your Stainless
Steel 5-, 10-, and 15-Gallon Pressure Tanks
instruction manual.
F . 4
IG
10
2. Refer to F . 4, page 6. Screw on the filler cap (F),
IG
or if the tank cover was removed, place the agitator
and cover on the pressure tank and secure the
cover with the c-clamp handles (M).
3. Close the tank air regulator(s) by turning the knob(s)
counterclockwise. Turn on the air supply.
4. To start the agitator, slowly open the needle valve
(20). Adjust the speed of the agitator with the needle
valve to about 40 to 60 rpm.
NOTICE
Do not operate the agitator at a high speed for a long
period of time. Excessive agitator speed can cause
foaming of fluid (making fluid unusable), or vibration
and increased wear on parts. Always agitate the fluid
only enough to maintain even mixing.
5. To stop the agitator, close the needle valve (20).
308371R