Whirlpool RF33OOXV Use And Care Manual page 19

Replacing
Burn, Electrlcal Shock and Fire Hazard
l
Make sure all surface unlts are OFF before replacing surface units and
reflector bowls. Failure to do so can result in burns or electrical shock.
l
Do not line the reflector bowls wlth foil. Fire or electrical shock
could result.
1.
Turn off ail surface units.
1. Hold the surface unit as level as
possible with the terminal just
started into the receptacle. Push
the surface unit terminal into the
receptacle.
Line up openings in the reflector
bowl with the surface unit recep-
tacle and the element hold down
clip.
#. When terminal is pushed into the
receptacle as far as it will go, push
down the edge of the surface unit
opposite the receptacle. The ele-
ment hold down clip will keep the
surface unit from moving around.
NOTE: Reflector bowls reflect heat back to the utensils on the surface
unlts. They also help catch spills. When they are kept clean, they reflect
heat better and look new longer.
If a reflector bowl gets dlscolored, some of the utensils may not be flat
enough, or some may be too large for the surface unit. In either case,
some of the heat that's meant to go Into or around a utensil goes down
and heats the reflector bowl. This extra heat can discolor it.