Water Tank; Weekly Coffee Circuit Cleaning; Weekly Cleaning Of The Milk Carafe - Saeco Tchibo Cafissimo HD8603 Operating Instructions Manual

8- Once everything has been washed
and dried, reinsert the used capsule
drawer.
9- Subsequently reinsert the drip tray.

Water tank

It is recommended that you clean the water tank daily under run-
ning water. In the case that limescale or other particles build on the
filter, remove and clean the filter as described here:
- Remove the white filter from the wa-
ter tank and wash it under running
water.
- Reposition the white filter in its
housing by gently pressing and
turning it at the same time.
- Rinse the water tank and refill it with
fresh drinking water.

Weekly coffee circuit cleaning

The coffee circuit must be cleaned weekly in order to maintain the
high quality of your coffee.
To perform this simple cleaning operation, proceed as follows:
1- Place a cup or glass underneath the coffee dispensing spout as
indicated in section "Adjusting the dispensing height".
2- Lift the lever for opening the capsule compartment in order to
remove any capsule there and do not insert a capsule.
3- Press the button (yellow) for a caffè crema.
4- Once the dispensing has finished, empty the residual water.
The machine is ready for use.

Weekly cleaning of the milk carafe

The milk carafe must be cleaned weekly if used. This cleaning - in
addition to the normal rinse - is to be performed after preparing any
product with milk.
1- Remove the milk carafe lid and wash both components in luke-
warm running water.
2- Fill the carafe up to the MAX level with fresh, cold drinking water
and replace the lid.
3- Insert the carafe into the machine and place a container under
the milk dispensing spout.
Warning! Dispensing may be preceded by small jets
of hot water: danger of scalding! If the carafe is ab-
sent, products requiring milk should not be selected.
4- With the machine turned on, press the Frothed milk button .
Wait until it has finished dispensing.
5- Press the rinse button
dispensing.
6- Empty the container and remove the carafe.
7- Remove the lid and empty out the remaining water in the carafe.
The components of the milk frothing system can now be carefully
cleaned by following these steps:
8- Remove the tube attached to the carafe
lid.
9- Push in the sides of the milk dispensing
spout (1) and remove it by pulling out-
wards (2).
(orange). Wait until it has finished
2
1
• 27 •
1