Table of Contents
Advertisement
P
P
P
/reset
1 s
P
/reset
<3 s
P
Β
Note!
For meaning of the error and diagnostic codes, see the error list in section Error history.
When an error has been acknowledged, it can still be read out from the error history.
36/61
Building Technologies
14.1.3
Display of operating position
V
h min s
%
V
h min s
%
14.1.4
Fault status messages, display of errors and info
14.1.4.1.
Display of errors (faults) with lockout
V
h min s
%
14.1.4.2.
Reset
:
V
h min s
%
V
h min s
%
Basic Documentation LMO39...
14 Operation:
Display oP: P1 stands for stage 1.
The display following oP is unit-specific.
Display oP: P2 stands for stage 2.
The display following oP is unit-specific.
The display shows Loc:. The bar under the fault status
message
appears.
The unit is in the lockout position.
The current error code is displayed (see Blink code table).
Example: Error code 7
When pressing
for 1 second, rESEt appears on the
/reset
display.
When the button is released, the basic unit will be reset.
When pressing
for
>
/reset
InFo, SEr and then OPErAtE.
When the button is released, the basic unit will be reset.
:
:
3 seconds, the display shows
CC1P7154en
:
15.03.2018
Advertisement
Chapters
Table of Contents
