Advertisement
2. Mounting the Flex Drive E
1. mounting
Tether the magnetic key and colored lanyard onto the deployment lever in
lowered position as shown below. The key will only reach the throttle after
you raise the deployment lever. This is a safety interlock feature.
(A) Align the coupling slots of the Flex Drive E upper unit with the slots on
the lower drive. Lower lever and carefully lower the unit until it is
seated. The front of the motor head must sit level with the aluminum
channel. If the coupling is not aligned, the motor may not function or
could be damaged.
(B) Tighten down the unit using the wing nuts. Do not over-tighten as you
could crack/damage the unit.
(A)
DEPLOYMENT
LEVER
MAGNETIC KEY
ON COLORED LANYARD
DEPLOYMENT
LEVER
(B)
6
TIGHTEN
SCREWS
NO GAP
Advertisement
