Advertisement
3. battery connection
4. Connecting to the Battery
You must purchase the appropriate connector kit for the battery you
selected for your Flex Drive E . You will need connect your battery as shown
below. NOTE: You will need to install the correct battery lug ring
connectors to connect terminal ends to the cable. Included in your motor
kit is a 3/8th" insulated lug connector. Our K2 batteries require a 1/4"
insulated lug connector; it is included in our lithium battery kits.
(A)
If not already connected, connect battery cable to appropriate battery
posts. (See instructions and safety information in the accessory kit)
(B)
Attach motor cable to battery cable by lining up arrows to meet and
pushing until it clicks.
(A)
RED
(B)
Securing the battery.
It is very important to secure your battery to the boat's deck while operating
or risk losing your battery in rough water or in a capsizing event.
K2 Lithium Batteries are sealed, waterproof, and come with a buoyant carry
case which can be easily secured using bungees.
Conventional lead acid batteries are heavy and should be situated on the boat
to ensure the boat remains trim. Always tie down lead acid batteries securely.
Lead batteries may leak and be damaged or cause adverse environmental
impact when submerged and cause injuries if unsecured and shifting.
RED
TO DISCONNECT
TWIST TO UNLOCK
TO CONNECT
10
RED
Advertisement
