Electronic Oven Control; Display; Start; Cancel - Whirlpool GS440LEL Use & Care Manual

1. Display

5. Oven Light Pad
2. Timer 6. Sequence Programming (on some models)

3. Clock

7. Oven Settings
4. Auto Clean
Display
When power is first supplied to the appliance, "PF" and the
current time will appear on the display. Press any pad to clear
"PF" from the display.
Any other time "PF" appears, a power failure has occurred. Press
any pad and reset the Clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a timed cook function, the display will show
either hours and minutes, or minutes and seconds.
The START pad begins any oven function. If not pressed within 5
seconds after pressing a function pad, the "START?" indicator
light will flash as a reminder. On some models, "START?" will
appear on the display.
If not pressed within 5 minutes after pressing a function pad, the
oven display will return to the time of day mode and the
programmed function will be canceled.

Cancel

The CANCEL pad stops any function except the Clock, Timer
and Control Lock.
This is a 12-hour clock and does show a.m. or p.m.
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK.
2. Press the HR or MIN "up" or "down" arrow pads to set the
time of day, including a.m. or p.m.
3. Press CLOCK or START.
8

ELECTRONIC OVEN CONTROL

Start

Clock
8. Warming Drawer (on some models)
9. Temperature
10. Timed Cooking
Tones are audible signals, indicating the following:
One tone
Valid pad press
Oven is preheated (long tone)
Function has been entered
Three tones
Invalid pad press
Four tones
End of cycle
Reminder, repeating each minute after the end-of-cycle tones
Reminder Tones
Reminder tones may be turned off. Press and hold STOP TIME
for 5 seconds. "rEP OFF" will appear in the display. Repeat to
turn reminder tones back on, and "rEP on" will appear in the
display.
All Tones
All of the above tones are preset on, all except the end-of-cycle
tones can be turned off.
To Turn Off/On: Press and hold START TIME for 5 seconds. A
tone will sound and "Snd OFF" will appear on the display. Repeat
to turn tones on and "Snd on" will appear on the display.

Fahrenheit and Celsius

The temperature is preset at Fahrenheit, but can be changed to
Celsius.
To Change: Press and hold BROIL for 5 seconds. A tone will
sound and "°C" will appear on the display. Repeat to change
back to Fahrenheit. To exit mode, press CANCEL.
11. Hour/Minute
12. Start/Control Lock
13. Cancel

Tones