Whirlpool FGP320A Use And Care Manual page 26

PROBLEM
Burner
flames are
uneven
POSSIBLE CAUSE
Burner ports are clogged.
SOLUTION
Clean with a straight pin (see pages
19 and 23). If this fails, call an
authorized Roper service technician
for service.
Burner Air/gas mixture is incorrect. Contact an authorized Roper service
flames lift off technician to check air/gas mixture.
ports, are
yellow, or
are noisy
when turned
Off
Burner makes Burner is wet from washing. Let dry.
popping noise
when on
Control
knob(s) will
not turn
You are not pushing in before Push control knob(s) in before
turning. turning to a setting.
Cooking The range is not level. Level range. (See Installation
results are Instructions.)
not what you
expected
The oven temperature seems Adjust the oven temperature control.
too low or too high. (See "Adjusting the oven temperature
control" on page 13.)
The oven was not preheated as Preheat oven if called for in recipe.
the recipe calls for.
The recipe has never been
tested or is not from a reliable
source.
Use only tested recipes from a
reliable source.
The pans are not the type or
size recommended in the
recipe.
Refer to a reliable cookbook for
recommended pan type and size.
There is not proper air circula- Allow 1 l/2 to 2 inches (4-5 cm) on all
tion around pan when baking. sides of the pans for air circulation.
There must be a minimum space of
1 inch (2.5 cm).
Flame size does not fit the
cooking utensil being used.
When broiling, you have not
completely closed the broiler
drawer.
Adjust flame size to fit cooking
utensil.
Completely close broiler drawer.
26