Lighting Standing Pilots - Whirlpool FGP320A Use And Care Manual

Lighting standing pilots
(models FGP320Y, FGP320A, FLP320A, and FLP3lOY)
To light range pilots:
1. Make sure all controls are turned off.
2. Remove the surface burner grates from
the cooktop. Lift the cooktop. (See "Lift-
up cooktop" on page 18.)
3. To light, hold a lit match over the pilot
light located between the front and back
burners. The pilot flame should be l/4 to
3/a in (.6-l cm) high.
4. If the pilot flame needs adjustment,
turn the pilot adjustment screw midway
down the length of the manifold pipe,
behind the control panel.
5. Lower the cooktop and replace the
grates before using the surface burners.
To light oven burner pilot:
1. Make sure the Oven Temperature
Control is turned off.
2. Remove the oven bottom (see "Remov-
ing the oven bottom" on page 21). Then
unscrew the burner baffle located on the
burner (see Installation Instructions for
more information about the baffle).
3. Hold a lit match over the oven burner
pilot located at the rear of the burner.
4. After the oven burner pilot is burning
steadily, check burner lighting by turning
the Oven Temperature Control to a
temperature above 140°F (60°C). The
burner will take 50-60 seconds to light.
5. Replace the burner baffle and oven
bottom.
11