Command-Line Parameters - IBM 10G Network Active Bypass User Manual

Command-line parameters

The 10G Network Active Bypass unit uses a command-line interface to configure programmable
parameters and monitor the unit status.
Permissions required
Only the Admin account has permissions to configure and check the system parameters.
Command-line parameters
You can view and configure system settings with the command-line interface. Press the "Tab" key to
show the next available commands. If the string is partially completed, press the "Tab" key or the
"Space" key to finish the string. When there is only one option, press the "Tab" or "Space Key" to
complete the next string.
At the N2818 prompt, type a question mark (?) to access the following commands:
Command
!
configure
exit
show
statistics
system
Select the show command and then type a question mark (?) to display the following options:
Options
authentication
bond
bypass
fan
ha
lfd
links
management-if
notification
sfp
statistics
system
tap
temperature
time
Select the configure command and then type a question mark (?) to display the following options:
30
10G Network Active Bypass V3.4: User Guide
Action
Comments
Enter configuration mode
Exit from the CLI
Display system or configuration information
Port statistics operations
System action
Description
Show authentication setting
Show bond
Show bypass information
Show fan information
Show high availability
Show Link Fault Detection information
Show link status
Show management interface information
Show notification setting
Show sfp information
Show port statistics
Show system information
Show tap information
Show current and highest temperature
Show time setting