Page 2
à domicile. sind. capable of remarkable performance. But it will reward Le PV1D incarne toutes ces qualités et il est capable Wir teilen seine Meinung und jedes von uns thoughtful installation; so, please take time to read this de performances remarquables. Il mérite cependant entwickelte Produkt basiert darauf.
Page 3
The setup parameters that can be the Important Safety Instructions in of the main speakers. With all the levels of PV1D set to configured and stored are: the accompanying leaflet.
Page 4
2. Unpacking the Subwoofer 3. Positioning the Subwoofer The PV1D is heavy and we strongly suggest that it is The PV1D may be used freestanding on the floor or be Note: Like all speakers, the proximity of room unpacked close to its final working position by two installed into custom-built furniture.
Page 5
Molex plug at one end and bare outputs, you may connect the subwoofer via its line wires at the other. As the input impedance of the PV1D level inputs. The PV1D accommodates two types of signal input.
Page 6
From time to time it may be necessary to update the output from a surround processor, use just one of the PV1D between the on and standby states in step with subwoofer’s internal software (firmware). This is done line input sockets on the subwoofer. It does not matter...
Page 7
SubApp™ PC program. any preset. If the PV1D is switched to standby and on Returns to the previous menu screen after again, the Volume Trim is reset to 0dB.
120 min Preset 5 Preset 5 180 min When the PV1D enters setup mode it will display the If Auto is selected, the PV1D will switch on Trigger 2 Enables any two PV1D presets to be selected in turn setup Home Menu illustrated above left.
Page 9
Line Sensitivity Normal +6dB Inverted -6dB It will help to have audio playing through the PV1D and Line input For a PV1D used to enhance the low frequency associated system while undertaking the audio setup Separate adjustment for Sensitivity and Gain performance of conventional stereo speakers, the Gain parameter must be set by ear.
Page 10
2. When using a surround processor, the internal The default is Speaker and the default speaker is the PV1D and the main speakers. Adjusting the phase can low-pass filter of the PV1D is not required, first named on the list after None.
Page 11
Loads one of the five presets for editing. Level Like EQ1, the bass is extended to the maximum Enables the preset to specify a PV1D volume level for the subwoofer. Edit different from that set to balance the inputs.
Page 12
So that the look-up table may be kept up to date, you can find it on the PV1D support page of our web sites. You may wish to reassess settings once the subwoofer is fully run in.
Page 13
The indicator will switch to white while the PV1D settings are stored and switch to red iii. The indicator will switch to white while the PV1D (normal Standby mode) again when the process settings return to their defaults and switch to red is complete.
Complies with Part 15 of the FCC Rules Operation is subject to the following conditions: 1. This device does not cause harmful interference and 2. This device must accept any interference received, including interference that may cause undesired operation. PV1D...