International comfort products A Series Installation Instructions Manual page 53

Component Self-Test
The control must be powered and the thermostat satisfied (no call
for heat or cool). Depress and hold the SW1 button for at least 10
seconds (but not more than 15 seconds), until the LED is blinking
in AMBER, then release. The control will execute the following
functions:
1. Inducer - - "Run" setting throughout the test
2. Hot Surface igniter - - On 15 seconds
3. Blower - - "Fan" Speed 15 seconds
4. Blower - - "Heat" Speed 15 seconds
5. Blower - - "Cool" Speed 15 seconds
6. Inducer Off
7. Return to Standby mode.
Once the Field Test Mode is initiated, all thermostat inputs will be
ignored until the field test sequence is completed. If the SW1
button is held for more than 15 seconds, the button press will be
ignored and the LED display will return to its prior state.
Troubleshooting
Refer to the service booklet. (Fig. 63)
440 01 4601 01
Fig. 63 - - Service Label Information
Care and Maintenance
FIRE OR EXPLOSION HAZARD
Failure to follow this warning could result in personal
injury, death and/or property damage.
Never store flammable or combustible materials on, near, or
in contact with the furnace, such as:
1. Spray or aerosol cans, rags, brooms, dust mops,
2. Soap powders, bleaches, waxes or other cleaning
3. Paint thinners and other painting compounds, paper
For continuing high performance and to minimize possible furnace
failure, periodic maintenance
Consult your local dealer and Owner's Manual
Specifications subject to change without notice.
WARNING
!
vacuum cleaners, or other cleaning tools.
compounds, plastic or plastic containers, gasoline,
kerosene, cigarette lighter fluid, dry cleaning fluids,
or other volatile fluids.
bags, or other paper products. Exposure to these
materials could lead to corrosion of the heat
exchangers.
must be performed on this furnace.
A190255
about proper
53