Linksys E2500 User Manual page 30

FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and devices.
• Connect the equipment to an outlet other than the receiver's.
• Consult a dealer or an experienced radio/TV technician for assistance.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
2.4GHz operation of this product in the USA is firmware-limited to channels 1 through 11.The device for the band 5150-
5250 MHz is only for indoor usage to reduce the potential for harmful interference to co-channel mobile satellite systems.
Mexico Regulatory Statement
La operacion de este equipo esta sujeta a las siguientes dos condiciones: (1) es posible que este equipo o dispositivo no
cause interferencia perjudicial y (2) este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda
causar su operacion no deseada.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 35 cm between the radiator and your body.
This device and it's antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter
except in accordance with FCC multi-transmitter product procedures.
Restrictions in the 5 GHz Band
The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to co-channel
mobile satellite systems.
This device has been designed to operate with an antenna having a maximum gain of 2.53 dBi and 3.37 dBi at 2.4 GHz
and 5 GHz respectively. Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required
antenna impedance is 50 ohms.
The maximum antenna gain (Please see the table below) permitted (for devices in the bands 5250-5350 MHz and 54 70-
5725 MHz) to comply with the EIRP limit and because high power radars are allocated as primary users (meaning they
have priority) in 5250-5350 MHz and 5650-5850 MHz, these radars could cause interference and/or damage to license
exempt LAN devices.