Power Supply; Setting The Time; Listening To The Radio - Teac CRX150 User Manual

19. SNOOZE indicator
20. FM indicator
21. AM indicator
22. AUX indicator
23. sleep indicator

POWER SUPPLY

AC: 220V ~ 50Hz
1. Insert the plug of power cord into a standard wall outlet.
2. Install the batteries in their compartment, 2x1.5V, battery type AAA/R03/UM4 (not provided) for back-up
For optimal performance, alkaline batteries are recommended. These batteries must be replaced every six months.
Use only the size and type of batteries specified. Respect the polarity indicated in the compartment. Improper polarity can cause
damage to the device. In order to avoid leakage, remove the batteries when unit will not be used for a long period of time. Do not mix
different types of batteries or old batteries with new ones.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
BACKUP SYSTEM: All settings are memorized, however, the clock time could occasionally need to be readjusted. In case of power
failure, if backup batteries are not installed, the screen will flash to indicate this power failure and the necessity to redo your settings.

SETTING THE TIME

1. In standby mode, press and hold
2. Press again to confirm.
NOTE: If during the adjustment time no key is activated in 9 seconds, the current display will be automatically stored.

LISTENING TO THE RADIO

1. Press once to turn on the unit.
2. Use the band selector FM/AM to select band.
3. Use the tuning control to tune to your desired radio station.
FM: For best reception, extend the FM wire antenna.
AM: Rotate the unit horizontally for optimum reception.
4. Adjust the volume level.
5. To stop listening to the radio, press
SETTING THE ALARM AND THE ALARM MODE
1. In standby mode, press and hold
HR. MIN.
2. Press and/or
3. Press then press HR. or MIN. to select the source of wake up:
4. Press to confirm. The alarm indicator
- If you use the sleep mode
- If you wake up with the radio, select your desired station.
- Do not forget to check the volume level.
* Same procedure applies for Alarm 2 with
STOPPING THE ALARM
1-Alarm repetition
button, the display will flash, set the time with
again to turn off the unit.
for a few seconds, the display blinks.
to set the time of wake up.
lights up.
with low sound level, you should use the buzzer to wake you up.
button.
HR.
hour and/or
buzzer or FM radio.
MIN.
minutes.