Advertisement
Installation
Fig. 3
Fig. 6
Building Technolegies
Fire Safety
Fig. 4
Fig. 7
-
+
Fig. 9
The strobe should be mounted 200 mm away from roof for ease the installation.
Steps:
1. Break out the cable entry at the bottom of base.
2. Connect DC 24 V power cable to the terminal" "" " (see Fig. 1 & 2 & 9). Pay at-
tention to polarity!
3. Select tone via DIP switch (see Fig. 10).
4. Press the top and push out to remove cover (see Fig. 3& 4).
5. Take out 2 screws from the back side (see Fig. 5).
6. Mount the base plate on a wall with the 2 screws (see Fig. 6).
7. Insert the cover bottom to the base first and then push top until close tightly (see
Fig. 7 & 8).
It would not cause any damage if inversed connected as the FDS181C is inversed
wired protection, but it will not work until the connection is correct.
Screw
Fig. 5
Fig. 8
Fig. 10
A6V10421535_a_en_--
Screw
2014-02-25
Advertisement
