Appendix; Simatic S7-300/S7-400, S7-1500 Components And Hmi In Comparison - Siemens SIMATIC S7-300 Manual For Migrating

7 Appendix

7 Appendix
7.1 SIMATIC S7-300/S7-400, S7-1500 components and HMI
in comparison
The following tables show the respective S7-1500 equivalent to the listed SIMATIC
S7-300/S7-400 module in terms of content.
It is essential that you note the following:
Note
The content of this table is for reference only!
In addition to the technical features listed in the tables, the components have
more technical properties which differ in some cases. Which technical features
are important and relevant to the respective plant/plant part can only be identified
through careful analysis of the installed base and must be determined in this
migration phase. See also
This means: The respective listed SIMATIC S7-1500 hardware component must
not automatically be regarded as an equivalent to the listed SIMATIC S7-300/S7-
400 component. It is the user's responsibility to consider the technical
characteristics (e.g., limits) of the SIMATIC S7 module and to check whether
these parameters are relevant to the customer application (plant) and complied
with.
Examples of relevant technical parameters:
Power supply
Signal voltage
Frequency
Connection to common potential or channel separation
Number of channels
Load current
Contact load
Switching rate
etc. ...
Migration S7-300/S7-400 nach S7-1500
Entry ID: 109478811, V1.1,
Planning the migration
05/2017
phases.
81