Check/Clean The Large Object Trap; To Remove The Large Object Trap; To Reinstall The Large Object Trap - Bosch SHX33AI Use And Care Manual

Figure 44/llus. 44
Figure 45/llus. 45
Figure 46/llus. 46
Figure 47/llus. 47
English
(Care and Cleaning Continued)
bucket or other appropriate receptacle.
Check/Clean the Large Object Trap
Your Bosch dishwasher has a filter system
made up of a Large Object Trap/Cylinder
FitterAssembty, as shown in Figure 45, and
a Fine Filter on the ftoor of the dishwasher
tub, as shown in Figure 46. Some modets
have an additional Micro Filter under the Fine
Filter, as shown in Figure 47. Check with the
Modet Features Chart on page 6 of this
manual to see if your model has the
additional Micro Fitter. During normal use the
filter system is self-cleaning. For your
convenience the filter system is accessible
and and easily cleaned.
The Large Object Trap prevents targe
objects such as bones, gtass, toothpicks
and straws from entering the pump system
and causing damage or noise. Frequenfiy
inspect the Large Object Trap and clean the
filter system whenever you find foreign
objects.
To Remove the Large Object Trap:
Grasp the ring handle, as shown in Figure
44. Turn the ring handle counter-clockwise
1/4 turn and lift out the Large Object Trap/
Micro Filter Assembly, as shown in Figure 45.
,_WARNING: DO NOT REACH
INTO THE LARGE OBJECT TRAP,
AS IT MAY CONTAIN SHARP
OBJECTS.
2. Carefully examine the Large Object Trap.
3. If you find debris in the Large Object Trap,
turn it upside-down and gently tap it on a
surface such as a countertop to dislodge
and remove the debris. Flush the Large
Object Trap clean by holding it under running
water.
4. You may also remove the other filter
system components, as shown in Figures
46 and 47, and flush them clean by holding
them under running water.
To Reinstall the Large Object Trap:
1. If you have removed the other filter
system components, return them to their
31aces, Micro Filter first (if your model has
it), Fine Filter second, and the Large Object
Trap/Cylinder Fitter Assembty last.
2. Firmly press the Large Object Trap/Fine
Filter Assembly into position.
3. Turn the ring handle clockwise 1/4 turn
until it is locked. The arrow on the ring
handle and the arrow on the Fine Filter
should point to each other, as shown in the
(Continued on Next Page)
46 Care and Cleaning t Entretien et Nettoyage I Cuidado y Limpieza