Switching On And Off; Recharging The Battery - IVT CED-3,6 Manual

Manual instruction

Switching on and off

Before connecting the device to the electric power
supply, make sure that the main supply voltage is
230V/50Hz.
(CED-3,6)
Switching on:
To switch the machine on, press the forward/reverse
power switch (9) in "
to the rotation you need. (fig. 1A)
EN
Switching off:
Release the forward/reverse power switch (9).
(CED-3,6L)
Switching on:
Select the rotation you need by pulling the forward/
reverse switch (4); then press and maintain the on/
off switch (6). (fig.1B)
Switching off:
Release the on/off switch (6).
fig.1A - fig.1B
Operating instruction

Recharging the battery

(CED-3,6)
1. Plug charger plug into a suitable mains socket
and plug the output cord of the charger into the
socket (8) of the screwdriver.
2. After charging 5 hours, the battery will be fully
charged. At this time, unplug the charger plug from
the wall socket: the screwdriver is ready to use.
(CED-3,6L)
1. Plug charger plug into a suitable mains socket
and plug the output cord of the charger into the
socket of the screwdriver, at this time the red
charging indicator (3) will illuminate.
2. After charging 3 to 5 hours, the battery will be
" or " " position depending
fully charged. When fully charged, the green light
will be on and the red light will be off. Unplug the
charger plug from the wall socket, the screwdriver
is ready to use.
WARNING: when charging, the charger
and screwdriver may become warm to
the touch, this is normal and does not
indicate a problem.
Fitting and removing bits
To use any of the bits supplied, insert the bit into the
chuck and push it into the chuck as far as possible.
To remove the bit, simply pull it out of the chuck.
NOTE: if using a short bit always use a
magnetic bit holder (fig.2)
fig.2
Manteinance and storage
Before carrying out any maintenance
operation, turn off the electric power
supply by disconnecting the plug from
the extension cable.
• Always keep the machine and the ventilation
slots cleaned. If the machine should fail despite the
rigorous manufacturing and testing procedures, the
repair should be carried out by an authorized IVT
customer service.
• Regular cleaning and maintenance of the
appliance will ensure efficiency and prolong the life
of your appliance.
• Keep all nuts, bolts, and screws tight, to be sure
the appliance is in safe working condition.
• Replace worn or damaged parts for safety.
• Store the appliance in a dry room out of reach of
12