Programming Without A Code; (When The Code Is Not Known) - Panasonic CT-34WX53 Operating Instructions Manual

Operating peripheral equipment using the remote control

Programming Without A Code

This procedure searches all codes and is called the "sequence method."
SAP
POWER
CH
VOL VOL
CH
BBE
RECALL
MENU
EXIT PAGE GUIDE
1 2 3
4 5 6
7 8 9
R-TUNE PROG
0
PIP MIN PIP MAX
PLAY
REW FF
REC
PAUSE STOP
FREEZE PIP CH SEARCH
TV/VCR VCR CH OPEN/CLOSE
PIP SPLIT MOVE SWAP
48
1
Confirm that the external component is plugged in and on.
2
Turn the component off.
3
+
POWER
VOL
4
5
CH
VOL VOL
CH
6
POWER
Press the Remote Control
successful, the component will turn on.
Note:
Repeat the above steps until the component code is found. It may take many
attempts before the correct code is found.
7
CH
VOL VOL
CH
Note:
The step and set mode will start from the current device (not the beginning of the
list, except for the first time).

(When the code is not known)

CH
Press POWER and ACTION together, for at least 5
seconds.
VOL
After 5 seconds, all the illuminated mode keys will
CH
begin to flash.
Release the POWER and ACTION key.
Press the mode key.
The mode key will illuminate steadily, all others will go
out.
Press to move forward to the next code, or to move
backward.
to test the component. If the procedure was
POWER
After the code is found, press ACTION to store the code.