Bosch SHE99CO5 Use And Care Manual page 19

Care and Maintenance
4. Look for obstruction in the spray nozzles.
5. If the spray nozzles need cleaning, flush
them under running water.
To reinstall the top spray arm:
1. Return the top spray arm to its installed
position.
2. Return the locking nut to its installed position
and turn it 1/8 turn clockwise.
3. Return the top rack to the top rack roller
guides.
To remove the bottom spray arm:
1. Remove the empty bottom rack from the
dishwasher tub.
2. Grasp and lift the bottom spray arm as
shown in Figure 29.
Figure 29
3. Look for obstruction in the spray nozzles.
4. If the spray nozzles need cleaning, flush
them under running water.
To reinstall the bottom spray arm:
1. Return the bottom spray arm to its installed
position and press it so that it snaps into
place.
2. Return the bottom rack to its installed
position.
Check/Clean the Stainless Steel Inner
Door and Tub
Clean the outer edges of the inside door panel
regularly to remove debris that might collect from
normal loading.
If spots begin to appear on the stainless steel
tub or inner door, make sure the rinse aid
reservoir is full.
(continued)
Check/Clean the Filter System
This dishwasher has a filter system that consists
of a Large Object Trap/Cylinder Filter assembly
and a Fine Filter. Select models have an
additional Micro Filter. The filter system is located
on the inside of your dishwasher under the lower
rack and is easily accessible.
During normal use, the filter system is
self-cleaning. You should occasionally inspect it
for foreign objects and clean it when necessary.
To Remove the Large Object Trap/Cylinder
Filter Assembly:
1. Remove the bottom rack.
2. Grasp the assembly as shown in Figure 30
and turn it counterclockwise 1/4 turn.
3. Lift out the assembly as shown in Figure 31.
To avoid injury, do not reach into the large
object trap with your fingers. The large
object trap could contain sharp objects.
4. Carefully examine the assembly. If you find
debris in the Large Object Trap, turn it
upside-down and gently tap it on a surface
such as a countertop to dislodge and
remove the debris. Flush the Cylinder Filter
clean by holding it under running water.
Figure 30
Figure 31
CAUTION
Large
Object
Trap/
Cylinder
Filter
17