Table of Contents
Advertisement
Base and Toe Pane,/Final
Instructions
BASE AND TOE PANEL (Continued)
PJaetic Base Access PaneJ and Toe PaneJ installation
(SHY66C, SH×99A, SH E66C, SHE99C, SH×57C, and
SHV57C modete only)
1 PUacethe PUastb Base Access PaneUunder and up the
front bottom paneUof the dishwasher, as shown in
Figure 34a,
2 insert the PUastb Base Access PaneUscrews into the
PUastb Base Access PaneU, as shown in Figure 34b,
Tighten the PUastb Base Access PaneUScrews,
3 PUace the Cotton UnsuUation Strip under the unit,
between the bottom of the Plastic Base Access Panel
and the floor, as shown in Figure 34c,
4 Attach the Toe Panel to the Plastic Base Access Panel
using the Toe Panel Screws included in the Toe Panel
Installation Kit, See Figure 34d,
NOTE: You will not use the normal Toe Panel Screws
included in the Dishwasher Installation Kit on these
models,
In some conditions,
Hydrogen
gas can form in a
hot water system that has not been used for
weeks.
Hydrogen gas is e×pJoeive. Before filling
a dishwasher
from a system that has been off for
weeks, run the water from a nearby faucet in a
wett ventilated
area untit there is no sound or
evidence of gas.
FINAL
mNSTRUCTmONS
1 Energize the dishwasher power supply circuit,
2 Consult the Dishwasher Use and Care Manual, and run
the dishwasher through one complete cycle, if the
dishwasher does not operate properly, refer to the Self-
Help section of the Use and Care Manual, if the
dishwasher still does not operate properly, refer to the
Customer Service Section of the Use and Care
Manual,
15
Advertisement
Table of Contents
