Lincoln Electric MAGNUM 200FM Manual page 18

E-3
PROBLEMS
(SYMPTOMS)
Poor arc striking with sticking or
"blast-offs", weld porosity, narrow
and ropy looking bead, or electrode
stubbing into plate while welding.
Tip seizes in diffuser.
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your
Local Lincoln Authorized Field Service Facility for technical troubleshooting assistance before you proceed.
TROUBLESHOOTING
Observe all Safety Guidelines detailed throughout this manual
POSSIBLE AREAS OF
MISADJUSTMENTS
a. Improper procedures or tech-
niques.
b. Improper gas shielding.
a. Tip overheating due to prolonged
or excessive high current and/or
duty cycle welding.
MAGNUM 200FM
a. See "Gas Metal Arc Welding
b. Clean gas cone. Make certain
a. Do not exceed current and duty
CAUTION
RECOMMENDED
COURSE OF ACTION
Guide" (GS-100).
that gas diffuser is not restricted.
make certain that gas cylinder is
not empty or turned off. Make
certain gas solenoid valve is
operating and gas flow rate is
proper.
Remove gun liner and check rub-
ber seal for any sign of deteriora-
tion or damage. Be sure set
screw in brass connector is in
place and tightened against the
liner bushing.
cycle rating of gun.
A light application of high temper-
ature antiseize lubricant (such as
Lincoln E2607 Graphite Grease)
may be applied to tip threads.
E-3