Cable Tv / Vhf, Uhf And Catv; Cable Tv; Vhf, Uhf And Catv - Panasonic TH-37PA20U/P Operating Instructions Manual

Cable TV / VHF, UHF and CATV

SAP
POWER
CH
VOL VOL
CH
PC
RECALL
MENU
Power switch
C.A.T.S sensor
Plasma C.A.T.S (Contrast Automatic Tracking System)
Plasma C.A.T.S automatically senses the ambient light conditions and
adjusts the brightness and gradation accordingly, to optimise contrast.
(Effective when Picture mode is set to Auto.)

Cable TV

When the antenna cable is connected to the TV antenna
terminal via a cable box or VCR, set the TV channel to
CH3 or CH4.
This does not apply when signal is input from VIDEO
INPUT.
Confirming
Confirm that registration with cable TV provider and
connection of equipment are completed. Turn the CABLE
BOX on and select the desired volume level.
1
Press
Press while pointing the remote control
2
POWER
towards the CABLE BOX.
Note:
The remote control code number is set
for Panasonic products.
When peripheral equipment does not
operate, reset code (See page 54 - 55).
3
Operate the CABLE BOX and select the desired
volume level.
VIDEO 3
ACTION INPUT VOLUME CHANNEL HPJ S-VIDEO VIDEO R AUDIO L PC
POWER
ACTION button
(Press to make
selections.)
INPUT button
(Change to input
signal.)
to confirm.
ANTENNA TERMINAL ON
THE BACK OF THE TV
Less than
4" (10 cm)
ACTION INPUT VOLUME CHANNEL
Operation can be done
from the TV set.
•
Channel selectors
•
Volume adjusters
Remote control sensor

VHF, UHF and CATV

Press
1
remote control.
2
Press to turn the TV on (See page 18).
POWER
3
Press to select the desired channel.
CH
VOL VOL
CH
4
Select the desired volume level.
CH
VOL VOL
CH
Notes:
(1) The channel number and volume level remain the same
even after the TV is turned off.
(2) Power consumption and howling sound can be reduced if
the volume level is lowered.
Ferrite core (large size)
(supplied)
To Antenna
Input
Incoming Cable
from Antenna or
Cable TV System.
INPUT
OUTPUT
CABLE BOX
INPUT 3
HPJ
S VIDEO VIDEO L AUDIO R PC
to operate the TV set with the
19