Vcr Connection - Panasonic TH-37PA20U/P Operating Instructions Manual

VCR Connection

Follow this diagram when connecting your television to a VCR only.
Use either the S-Video or
the Video connection.
S-VIDEO
VIDEO
L
AUDIO
R
ANT INPUT
ANT OUTPUT
VCR
Note: The remote control must be programmed with supplied codes to operate the VCR (see page 56, 57).
Viewing a television program
Procedure
1. Select ANT1 in the SET UP menu. (See page 24)
2. Tune the television to the television program you would like to view.
Viewing a video
Procedure
• Option A
1. Press the TV/VIDEO button on the remote control to select the video input (VIDEO 1, VIDEO 2, etc.) connected to your VCR.
2. Begin the video.
• Option B
1. Select ANT2 in the SET UP menu.
2. Tune the television to Channel 3 or 4, depending on your VCR.
3. Begin the video.
Recording a television program
Procedure
• Option A (Recording and viewing the same program)
1. Select ANT2 in the SET UP menu.
2. Tune the television to Channel 3 or 4, depending on your VCR.
3. Using the VCR, tune to the television program you would like to record.
4. Begin recording.
• Option B (Recording one program while viewing another program)
1. Select ANT1 in the SET UP menu.
2. Press the TV/VIDEO button on the remote control to select the video input (VIDEO 1, VIDEO 2, etc.) connected to your VCR.
3. Using the VCR, tune to the television program you would like to record.
4. Begin recording.
5. Press the TV/VIDEO button on the remote control to switch back to TV mode.
6. Tune the television to the program you would like to view.
COMPONENT VIDEO INPUT
S VIDEO
PROG OUT
VIDEO
L
TO AUDIO
AMP
R
CABLES NOT SUPPLIED
CONNECTIONS ON BACK OF TV
1 2
INPUT
1 2 Y
P
B
VIDEO
P
R
Incoming Cable
Cable Connection
ANT 1 SPLIT ANT 2
OUT
DIGITAL
IN
Less than
4" (10cm)
L
AUDIO
R
Ferrite core
(large size)
(supplied)
13