Table of Contents
Advertisement
The installation must comply with applicable federal, state, and local codes having jurisdiction at your location. Utilize only
qualified beverage equipment service technicians for installation.
A Service Company Directory may be found on our website, http://www.fetco.com.
Setup
1. Before placing the unit, verify that it will fit in the space intended for it, and that
the counter or table will support its' weight.
2. When the unit is in position, use a bubble level to level it front to back and side
to side by adjusting the legs.
Water Connection
1. Water inlet is ¼ inch flare fitting.
2. Install a shut off valve near the unit to facilitate service.
3. Install a backflow prevention device, a spring loaded double check valve such as a
WATTS SD-2 or SD-3 is usually accepted by most zoning authorities.
4. If an inline water filter is used (highly recommended), it should be installed after the
water shut off valve and in a position to facilitate filter replacement.
5. Flush the water supply line and filter before connecting it to the unit.
6. Verify that the water line provides at least 1½ gpm (5.7lpm), and that the water
pressure is between 40-75 psig, (276-517kPa).
Venting brewer and vent drain
When the HWD_2102 is initially filled and powered "ON", water may flow
from the vent drain. This is normal, and caused by expansion of the large amount
of cold water in the hot water tank.
All equipment with vent drains should be attached to tubing that exits into a
plumbed drain system.
Attach a Vent Drain
A drain line should be used for the tank vent.
Materials: use ¼" i.d. heavy wall silicone tubing or 3/8"i.d. rigid tubing only.
IMPORTANT: Allow a 4" to 12" air-gap from the end of the drain line to main drain.
Consult local plumbing codes.
Installation
6
Warning: Legs are to be adjusted
!
only to level the unit. Do not extend
them higher than necessary
Back panel of HWB-2102
Connection
Power
Switch
Water
Supply
Tank
Inlet
Drain
DRAIN VENT DIAGRAM
From HWD vent
Vent receiver and drain line
! Must provide air-gap to drain!
Tank
Vent
Electrical
Advertisement
Table of Contents
