Table of Contents
Advertisement
Installation
instructions
BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS
COMPLETELY AND CAREFULLY.
Installing
your microwave oven
1.
Empty the microwave
oven and clean
inside
it with a soft, damp
cloth. Check
for damage
such
as misaligned
door, damage
around
the door
or dents inside the oven or on the exterior. If there
is any damage,
do not operate
the unit until it
has been checked
by an authorized
Whirlpool
service
technician
and any repairs made.
3. Do not block
the vent openings
on the rear
of the oven or the air intake
openings
on the
bottom
of the oven. Blocking
vent or air intake
openings
can cause poor cooking
results. The air
from these vent openings
will also contain
mois-
ture and should not be vented
onto overhead
cabinets.
Make sure the microwave
oven legs are in place.
Do not set the oven on anything
that will block the
air intake openings.
2. Put the oven on a cart, counter, table or shelf
that is strong enough
to hold the oven and the
food and utensils you put in it. (The control
side of
the unit is the heavy
side. Use care when han-
dling.)
The weight
of the oven is approximately
70
Ibs. (31.75 kg).
TOP
SIDE
ONE
SIDE OR TOP
MUST
HAVE
AT LEAST
1 CLEARANCE
SIDE
4. Do not install the microwave
oven so that
both sides and the fop are flush with walls or
cabinets.
One side or the top must have at least
1 in. (2.54 cm] clearance
for proper
operation.
Do not install the oven next to a conventional
surface unit or in any area where excessive
heat
and steam are generated.
This could damage
the outside of the cabinet.
Advertisement
Table of Contents
