Removing The Oven Door - Kenmore SELECT CLEAN 665.75822 Use & Care Manual

SEALED SURFACE BURNERS AND COOKTOP (contd.)
To clean the burners:
1.
Remove the burner cap from the
burner base.
2.
Clean the burner cap with warm, soapy water
and a sponge. You can also clean it with a
mildly abrasive scrubbing pad or cleanser.
Do not clean the burner cap in a dishwasher or
self-cleaning oven.
3.
If the gas tube opening has become soiled or
clogged, use a damp cloth to clean the area.
4.
If the burner ports are clogged, clean them

REMOVING THE OVEN DOOR

For normal use of your range, you do not need to
remove the door. However, if you find it necessary
to remove the door, follow the instructions in this
section.
NOTE: The oven door is heavy.
Before removing the door:
1.
Use a putty knife or screwdriver and insert it at
the bottom corner of the door stop clip.
2.
Pry door stop clip free and remove from front
frame hinge slot. Take care not to scratch
porcelain.
3.
Repeat procedure for other door stop clip.
5.
with a straight pin.
Do not enlarge or
6.
distort the port. Do
not use a wooden
toothpick. If the
burner needs to be
adjusted, call a
qualified technician
for service.
Door removal
pin hole
CARING FOR YOUR RANGE
After cleaning the gas tube opening and ports,
Gas tube opening
Turn on the burner to see if it will light. If the
INCORRECT
CORRECT
Door stop clip
Hinge
Front frame
hanger
hinge slot
replace the burner
cap. To replace the
burner cap, make
sure the alignment
pins on the cap are
properly aligned with
the burner base.
burner does not light
after you have cleaned it,
recheck cap alignment or
contact a Sears Service
Center. Do not service
the sealed burner your-
self.
Range
continued on next page
33