ZyXEL Communications ARMOR G1 User Manual page 129

Figure 76 Settings > Firewall > IPv6 Firewall > Add Rule
The following table describes the labels in this screen.
Table 45 Settings > Firewall > IPv4 Firewall > Add Rule
LABEL
Service Name
MAC Address
Dest IP Address
Source IP Address
Dest Port Range
Source Port Range
Protocol
Apply
Cancel
Chapter 12 Security
DESCRIPTION
Enter a name that identifies or describes the firewall rule.
Enter the MAC address of the computer for which the firewall rule applies.
Enter the IP address of the computer to which traffic for the application or service is
entering.
The NBG6818 applies the firewall rule to traffic initiating from this computer.
Enter the IP address of the computer that initializes traffic for the application or
service.
The NBG6818 applies the firewall rule to traffic initiating from this computer.
This is the port number/range of the destination that define the traffic type, for
example TCP port 80 defines web traffic.
This is the port number/range of the source that define the traffic type, for example
TCP port 80 defines web traffic.
Select the protocol (TCP, UDP or ICMP) used to transport the packets for which you
want to apply the firewall rule.
Click Apply to save the settings.
Click Cancel to exist this screen without saving.
NBG6818 User's Guide
129